Wall Solution

60 min. Before plastering the wall surface is carefully cleaned steel brush off dust and dirt. If the seams are embroidered, they are choosing a depth of not less than 1 cm, so the solution is better behaved on the brickwork. Then you do provesku walls. This work is very laborious. To ease her, do the following. Score a strictly plumb on two nails, first in one corner, then another at 15 …

20 cm from the ceiling and floor. On two nails in the vertical pull cord and push it under the third nail in the middle of the wall. Then pull the wire across and over 1.5 … 2 m (depending on the length of the wall), drive a desired number of nails. After that, every nail, place it flush with the solution of a hat and give it shape brand. On them will do beacons. When proveske walls of brick, breeze blocks, laid in cement mortar of different brands, it's hard to hammer a nail.

In this case it is better to use a brand-lighthouse (Fig. 1), made of dowels with metal cap. To remove it from the mortar or concrete, enough to knock twice on the side of the cap with a hammer. The resulting small vacuum sealed with a solution. Plaster carry beacons, which are made of wooden slats thickness of 3 cm, a width of 3 … 5 see them nailed to the wall vertically, with its ends on the same horizontal line. Before the work surface of the walls is wetted with water. Then the liquid (creamy) solution makes spraying a layer of 1 cm, causing more dense solution (ground) and level of its wooden lath (the rule) on a par with the beacons. Ground caused by completely covering the top liquid solution, strained through a fine sieve, and well leveled. This solution is called nakryvki. As soon as he grabbed his overwritten, wooden lighthouses are removed, and their nests are sealed with a solution and will be overwritten. Plastered surfaces can be painted, it is best calcic compositions. If the plaster surface of the wet spots reappear, you must carefully observe the flow of water from the roof, basement, foundation and blind area. In appropriate places to carry out repairs. In the current repair or reconstruction work after the (repair roofs, floors, installing walls, fill the window and door openings, their repair, relocation of furnaces and repair, etc.) begin to interior decoration of residential and outbuildings. To plastering walls and ceilings, apply solutions, compiled on the basis of hydraulic (cement, hydraulic lime) and air (lime, gypsum, clay) binders. Stuccoing inside the house operates on the same technology as the outside. If you allow the wet plaster ceiling, then begin to work with her. For the convenience of ready-made nail (interlaced) dranochnye shields. In the bathroom laundry rooms and wooden floors load-bearing structures (beams, planks) are left open. After that, when selected paneling, plaster walls, and then the furnace. If you do this job properly, the plaster can be quite a long time. Should not seek to trim tiles or tile stove in solutions, adhesives or mastic, as they have different coefficients of expansion and the tiles do not stick. The solutions used different. For the strength of reinforced fibrous materials, asbestos is usually grade VII. You can use finely chopped slag or glass wool. All materials for solution of sieved on a sieve 3×3 mm, and measure accurate three-dimensional doses (parts). The solution should be thoroughly mixed. The following are the compositions of some solutions.